Input voltage range |
17-32Vdc |
Output |
13.6Vdc +15% -20% at extremes of temperature, load, input tolerance, etc. |
Intermittent output power |
As stated, taken for a maximum of 2 minutes followed by 8 minutes rest. |
Transient voltage protection |
Meets ISO7637-2 International standard for 24Vdc commercial vehicles |
Electrostatic voltage protection |
Meets ISO10605, ISO14892, >8kV contact, 15kV discharge |
Output noise |
<50mV pk-pk at continuous load. Meets CISPR25 |
Off load current (quiescent current) |
<15mA |
Power conversion efficiency |
Typically: 90% for non-isolated units, 85% for isolated units, *95% |
Isolation |
>400Vrms between input, output and case, on isolated products only |
Operating temperature |
-25ºC to +30ºC to meet this specification table
+30ºC to +80ºC de rate linearly to 0A |
Storage temperature |
-25ºC to +100ºC |
Operating humidity |
95% max., non-condensing |
Casework |
Anodised aluminium, glass filled polycarbonate, dust water and impact resistance to IP533 |
Connections |
Four 6.3mm push-on flat blade connectors, *5 way Phoenix connector including enable on/off terminal and mating half |
Output indicator |
Green LED adjacent to output terminals |
Mounting method |
‘Click ‘n’ fit mounting clip, fitted separately using three hole fixture, *4 hole cradle |
Safe area protection:
Over current |
Limited by current sensing circuit |
Over heat |
Limited by temperature sensing circuit |
Transients |
Protected by filters and rugged component selection |
Catastrophic failure |
Protected by internal input and output fuses |
Approvals |
2014/30/EU The general EMC directive
Regulation 10 The automotive directive
93/68/EEC The CE marking directive |
Designed to |
EN50498, ISO 7637-2, ISO 11452-1, ISO 14982, EN12895, EN60945, EN55022, FCC15B |
Markings |
CE and E (automotive) marked |